Design the air
you could never see.
Change air ring pressure, temperature and blow-up ratio to see how airflow and cooling efficiency respond. Watch the bubble size on screen while you set airflow and pressure for each lip.
A tool to design the air ring,
the air and the cooling yourself
Short neck and long neck
Long necks come in three types (standard, IBC and 3rd-generation IBC), with adjustable stabilizer height.
Single · Dual · Triple lips
Keep total airflow fixed and set the airflow, pressure and gap for each lip.
Airflow matched to the frost line
Set a target frost line height and airflow is adjusted automatically to reach it.
Airflow from pressure
Set the pressure and the matching airflow is calculated automatically.
Diffuser opening
See how the Venturi and Coandă effects change as diffuser holes open and close, by opening ratio.
Lift and lower cooling
When the air ring is raised, see the triple lip cooling below the ring, down to the vortex at the lower lip.
Air temperature inside the bubble
Enter the ambient temperature and the die-to-take-up distance to calculate the air temperature inside the bubble. The difference with and without IBC shows right away.
Reference settings
Suggests settings with less bubble movement and better cooling, as a reference.
Input ranges
The ranges are wide, so you can try a broad range of shop-floor conditions.
- BUR
- Up to 6
- Film width
- Up to 3,500 mm
- Output
- Up to 1,000 kg/h
- Total airflow
- Up to 200 m³/min
- Supply air temperature
- 10~40 ℃
- Lift (short neck)
- 0~400 mm
- Lift (long neck)
- 0~700 mm
- Ambient temperature
- −20~60 ℃
- Die to take-up distance
- 2~25 m
Let's design the air
for your line together.
Tell us your die diameter, neck type and air ring lip setup, and we will show you the results for those conditions.