05 · STANDARD AIR RING

Short neck or long neck,
one frame.

A standard air ring drawn by PLAN B. Short and long necks differ only in lip angle and share the same frame. Choose single, dual or triple lips to set the air path.

  • Shared short/long-neck frame
  • Single · Dual · Triple
  • Lift frame
Plenum body Upper diffuser Lip Lift frame Die
STRUCTURE

Structure

  1. 01

    Plenum body

    The main body takes in air from the blower and sends it to the lips.

  2. 02

    Upper diffuser

    Not a cylinder rising above the body, but a perforated diffuser set inside it.

  3. 03

    Lift frame · Columns

    Raise and lower the air ring along the columns to set its height.

  4. 04

    Lower diffuser

    Fitted only when triple lips are used with a lift.

AIR PATHS

The lip setup decides
where the air comes out.

Changing the lip setup does not change the lip angle.

  • S

    Single

    Air rises through the outer channel and exits below the upper diffuser.

  • D

    Dual

    Air exits from the cone side of the inner lip.

  • T

    Triple

    Air exits downward through the lower diffuser. Raise the ring with the lift and it also cools the bubble below the ring.

SHORT NECK · LONG NECK

Same frame,
different lip angle.

SHORT NECK

Short neck

The lip angles along the bubble, so the air rides up the outside of the bubble.

LONG NECK

Long neck

The upper lip turns 90°, so the air travels straight up along the neck.

WITH THE SIMULATOR

Run the numbers
before you install.

The 3D air ring in the Air Ring Simulator follows this drawing exactly. Enter your line's die, BUR and output to check airflow and cooling first.

Let's choose the right air ring
for your line.

Tell us your die diameter, neck type and output, and we will review the lip setup and lift to match.

Air ring inquiry